+54 9 11 35374801
PerMix Powder Mixer

PerMix Conical Mixers

PerMix Mexico

Since 1954 PerMix has been leading the industry in Plow Mixer technology, manufacturing Vale Added Engineered products that outperform our competitors, offer the best warranty, while also guaranteeing the best price.

Conical Auger Mixer Introduction

The PerMix PNA series Conical Auger Mixer, also known as a Nauta Mixer®, is a batch mixing equipment used widely in applications that require gentle mixing and minimal heat generation without any product distortion. Because no seals or bearings are exposed in product zone, there is no risk of lubricant contamination. The PerMix PNA series Conical Mixer is featured by its very low energy consumption, low maintenance cost, but high performance of mixing.

A spiral screw (or two, three screws according to specified application) inside of a PerMix PNA series Conical Auger Mixer rotates by its own axle parallel and near the wall of the cone vessel. It lifts the powders around it from bottom to the top, and then the powder falls down due to the gravity. At the same time, the spiral screw rotates around the center of the cone like a planetary, so that the powders in every corner of the cone can be mixed by the screw.

a. Screw Type
We offer single screw, double screw and triple screw to give different mixing intensity.
b. Drive system
Drive system by geared motor, cycloidal reducer, worm reducer, belt or chain transmission, etc.
c. Construction Material and Finish
We are able to offer our PVR Mixers with contact part to be built in Carbon steel, SS304, SS316/316L, Titanium, Duplex stainless steel, Hastelloy, etc. Finish of internal and external finish can be dull polished, 180 grit polished (food grade), or mirror polished. For abrasive materials we offer hardened steel as the contact part.
d. Heating/Cooling jacket
Jacketed trough for heating/cooling operation
e. Vacuum drying & deaerating
The PNA mixer can be designed for vacuum drying & deaerating or for inner pressure working for special applications.
f. Spray nozzle
Liquid can be added into the powder by spray nozzles on the top.ods for the PS series Bottom Entry Mixers. It can be lifted up by a lifting stand (hydraulic or electric), or it can be installed with flange on the top of a tank, or from its side, or at its bottom. For the vacuum or pressurized tank, the mixer must be equipped with a mechanical shaft sealing.

Conical Mixers

  1. Conical Auger Mixers have no minimum volume required
  2. Conical Auger Mixers offer complete discharge of materials
  3. Conical Auger Mixers offer easy cleaning of the machine
  4. Conical Auger Mixers offer gentle mixing for fragile and friction sensitive materials
  5. Conical Auger Mixers are free of cross contamination with shaft sealing above the product

PerMix Conical Mixers Videos

Free Consultation

Schedule a free consultation today!
We offer free consultations and estimates. Contact us today to get in touch with our product expert.